LEE, EZ X EXP 6.5X55 #SE2425

Designed to facilitate the decapping of 6.5mm chambered rifles, this primer puller fits into compatible Lee dies to ensure clean and repeatable primer extraction. It is suitable for workshop environments and demanding reloaders working with historical or modern cartridge cases.

Detailed compatibility

The part is compatible with the following tools and die sets (non-exhaustive list):

• RGB DIE 6.5x55 (Code 90874)
• 6.5 Carcano PaceSetter Die Set (Code 90749)
• RGB 6.5 Creedmoor (Code 91556)
• 6.5 Creedmoor PaceSetter (Code 91821)
• 6.5 Creedmoor Breech Lock PaceSetter (Code 91920)
• 6.5 Creedmoor Ultimate Rifle (Code 90939)

Calibers covered

Optimized for size 6.5, the needle is suitable for the following dimensions:

• 6.5 JAPANESE
• 6.5 CREEDMOOR
• 6.5 GRENDEL
• 6.5 PRC
• 6.5x57 MAUSER
• 6.5x57R
• 6.5x47 LAPUA
• 6.5x55 SWEDISH
• 6.5 CARCANO

Materials & Care

Machined from hardened steel , the needle is designed for repeated use; perform regular visual inspections and replace if deformed or worn. Clean after use and lightly lubricate if stored for extended periods to prevent corrosion.

Assembly and precautions

Mount only on the tools listed above or on equipment compatible with the stated thread and length. Do not force; use appropriate guiding tools to avoid damaging the tip and the inside of the case. Observe safety precautions (check for the absence of pressurized components, remove all live ammunition before handling).

FAQ

• Q: Is this needle suitable for my Lee Classic press or only for the listed models?
  It is designed for EZ X EXP tools and the sets listed; check the thread and length before fitting on other presses.
• Q: What is the exact length in millimeters?
  The length is 3.370" or ≈ 85.60 mm.
• Q: How can I tell if the needle is worn?
  Check the straightness and condition of the tip: any deformation, chipping or loss of dimension implies immediate replacement.